Table of Contents
Advertisement
34 | Installation
1
4
Fig. 52 Fastening the electrical leads
1
Sensor wells
2
Sensor retainer
3
Cable entry
4
Cable clip
B Establishing the electrical connection as shown in the
wiring diagram. Take care to ensure correct cable and
capillary pipe routing.
Secure all cables with cable clips.
B Insert cable clips with cable inside into the clip frame
and secure by clamping it with the tab.
Fitting the rear panel section and terminal cover
B If necessary, push/cut the knock-out section out of
the rear panel section.
B Hook the lower hook on the rear panel section into
the clip frame and apply pressure at the top until the
side hooks click into place.
B Screw terminal cover onto the control unit base again.
6 720 803 940 (2010/03)
2
3
6 720 648 663-41.1T
Fig. 53 Fitting the rear panel section
1
2
1
Side hook
Rear panel section (control unit)
2
6 720 648 663-47.1T
UNI 7000 F
Advertisement
Table of Contents
