Bosch. safeguard them for future reference. You can download this manual from the local home pages of Bosch. General safety instructions ❐ The iron must not be left unattended while it is connected to the supply mains.
Important notices • In special environmental conditions slight instability may occur. • This appliance has been designed • The appliance must never be placed exclusively for domestic use and must directly under the tap to fill the water not be used for industrial purposes. tank.
ºC 2. Heating Remove any labels or protective covering from the soleplate (10). Plug in the iron. “SensorSecure” function will be activated and the indicator lamp (2) will flash. The “TempOK” indicator lamp (1) will flash, indicating that the iron is heating up. When the iron is ready to use, the indicator lamp will remain lit continuously.
4. Steam settings The steam regulator (5) is used to adjust the amount of steam produced when ironing. Steam setting Steam regulator High steam flow Medium steam flow Dry ironing Tip: Try to iron the fabrics while they are still damp after washing.
7. Spray Spray can be used to remove stubborn wrinkles. When ironing, press the spray button (3) and water will spray out of the spray nozzle (7) onto the garment. Tip: Do not use the spray function with silk. 8. After ironing Unplug the iron from the mains socket.
Cleaning & Maintenance Attention! Risk of burns! Always unplug the appliance from the mains supply before carrying out any cleaning or maintenance operation on it. If the iron is only slightly soiled, pull out the plug and allow the soleplate (10) to cool down. Wipe the housing and the soleplate with a damp cotton cloth only.
Page 10
Plug in the iron. When the lamp “TempOK” (1) remains lit continuously, unplug the iron (very important!). Hold the iron over a sink. Press the “clean” button (9) and shake the iron back and forth keeping it in a horizontal position until approximately one third of the water capacity of the tank is evaporated.
Trouble shooting Problem Probable cause Solution The iron does not The “SensorSecure” function Grip the handle of the iron to heat up. has been activated. The iron re-start it. is set to stand-by. Water drips out of the You have pressed the shot of Wait 5 seconds between each soleplate when using steam button (4) repeatedly...
Page 12
Customer Service Great Britain Bosch Customer Service UK +44 (0)344 892 8979 Grand Union House IRL +353 (0)1450 2655 Old Wolverton Road Milton Keynes www.bosch-home.co.uk MK12 5PT 001 Sensixx’x DA70 GB EasyComfort 03/16 9001192421...