Table of Contents
Advertisement
32 | Installation
B Hook the front hood ("A") into the slots on the
lengthways bar and push forwards.
B Screw rear of hood "A" to each lengthways bar using
one self-tapping screw.
1
2
Fig. 47 Fitting the front hood "A"
1
Hooks
2
Slot in lengthways bar
B Push folded edge of 400 mm wide hood ("D") under
the front hood.
1
2
Fig. 48 Fitting hood "D"
1
Hood "D"
2
Front hood
Before the remaining hood sections are put
in place, the control unit must be fitted, the
capillary tubes fed to the sensor wells and
the sensors placed in the sensor wells (‡ see
Chapter 4.16.1, page 33 ff.).
B Screw the upper boiler rear panel to the rear of the
hood and the side panels.
6 720 803 940 (2010/03)
B Screw the lower boiler rear panel with the cut-out for
the fill and drain connection down onto the side
panels.
6 720 648 663-36.1T
Fig. 49 Fitting the upper and lower boiler rear panels
1
Upper boiler rear panel
2
Lower boiler rear panel
B Screw left/right front panel section to the cast lug on
the burner door, using four hexagon bolts for each.
B Hook burner door panel into the cut-outs in the front
panel.
6 720 648 663-37.1T
Fig. 50 Fitting the left and right front panel
1
2
6 720 648 663-38.1T
6 720 648 663-39.1T
UNI 7000 F
Advertisement
Table of Contents
