Beko Hll74700UF User Manual page 26

A Your hob may be equipped with
V hobs with a diameter of 145, 180,
210 and 280 mm with induction
feature depending on the model.
Thanks to the induction feature,
each hob zone automatically
detects the pot placed on it.
Energy occurs on the contact
area of the pot only, and thus
minimum level of power is
consumed.
Automatic turning off system
The hob control has an automatic turn
off system. lf one or more hob zone(s)
are left on, the hob zone turns off
automatically after a while (See Table-1).
In case of a timer assigned to the hob
zone, the timer display is turned off then,
too.
The time limit for automatic turn off
depends on the selected temperature
level. Maximum operating period is
applied for this temperature level.
The hob zone may be operated by the
user again after it is turned off
automatically as described above.
Table-1: Automatic turning off periods
0
2
3
4
5
6
26/EN
0
6
6
5
5
4
4
7
8
9
Quick Heating
While the temperature level is increased
as 1,2,3 ... 19 on some models, it may be
increased as 1, 1.,2,2 . ... 9. on some
other models. This varies as per product
model.
Overheating protection
Your hob is equipped with some
sensors that ensure protection against
overheating. You may observe the
following in case of overheating:
• The hob zone that is operating may be
turned off.
• The selected level may be reduced.
However, this is not reflected on the
display.
Overflow protection system
Your hob is equipped with an overflow
protection system. In case of any
overflow on the control panel for any
reason, the system cuts off the power
connection automatically to turn off your
hob. At this time, "F" symbol appears on
the display.
Precise power setting
lnduction hob responds to the
commands issued immediately as per its
operating principle. lts power settings
are changed very rapidly. Thus, you may
prevent overflowing of a meal (water,
milk) that is about to overflow by turning
the appliance off immediately.
2
2
10 minutes