Table of Contents
Advertisement
AHP60 26/32 kW - Installation, Use and Maintenance
It normally displays the water outlet temperature in tenths of a degree Celsius or the alarm code
is displayed if there is at least one alarm in progress. If several alarms are in progress, the first
one is displayed, while the second one is displayed after the first one has been reset.
Menu
Below is a description of the main navigation functions in the menus, also explaining some
functions that are harder to understand. The main menu also managed the following sections:
MENU
Setpoint *
Sensor
Alarms
Digital inputs
Parameters
Password
Hours of operation
USB
Firmware version
Error history
Access the PSS menu to enter the maintenance technician password "195" and to activate
access to a higher level. Once all of the menus have been quit, the password privileges are lost
and the password needs to be entered once again.
5.2. "Set" setpoint menu
SETPOINT
Coo
Hea
Coo2
Hea2
The different setpoints can be displayed and modified. This menu is not used automatically with
Ecomod Heat Pump Control.
Note: To operate manually without connection to the Ecomod Heat Pump Control, the
pairing between the 2 must be cancelled:
Power down the Ecomod Heat Pump Control or disconnect the communication bus
between the 2, then switch off the heat pump for a few seconds via the proximity switch,
then restart it
50 / 74
LABEL
PASSWORD LEVEL
Set
tP
Installer
Err
Id
Installer
Par
Installer
PSS
oHr
Installer
USb
Installer
Fir
Installer
Hist
Installer
(For manual operation only)
DESCRIPTION
- not used -
Setpoint in manual operation without Ecomod Heat
Pump Control connected. (Manual mode)
- not used -
- not used -
Manual operation without Ecomod Heat Pump
User
User
User
Only if a USB stick is present, see "software"
OTHER CONDITIONS
Control
---
Only if errors in progress
---
---
---
---
instructions
---
Only if there is data in the history
UNIT
BY DEFAULT
--
--
°C
45.0
--
--
--
--
00U07352250-A_ EN
RANGE
--
25 ÷ 60
--
--
Advertisement
Table of Contents
