Table of Contents
Advertisement
To change the setpoint, select the setpoint function and
change the value to 65°C
Return to the home screen by selecting the back arrow and
then the home symbol.
The display will change to the following:
Primary flow temp
Hot water temp
Outside temp
Primary water flow
Compressor
CH1 Pump
CH2 Pump
Diverter valve
Immersion heater
If you are installing a Halo Air alongside the Logic Air.
Proceed to section 5.7.3. (Section 5.7.2 is for reference
only).
for Halo Air
Installation and Maintenance
Section 5 - Commissioning
08:32
20.0ºC
20.0ºC
3.1ºC
10l/min
100%
Off
Off
DHW
Off
SCAN
Installation
Guide
5.7.2 Menu Operation
SETTING THE CENTRAL HEATING TIME PROGRAM
On/Off non-programmable room stats only
Primary flow temp
Hot water temp
Outside temp
Primary water flow
Compressor
CH1 Pump
CH2 Pump
Diverter valve
Immersion heater
Starting from the Home Screen (see above), to set a central
heating programme, rotate the dial until the thermometer icon
in the left-hand column is highlighted and press the dial. The
following screen will be shown:-
Heating
Primary flow temp
Flow temp setpoint
Room temperature
Time program
Press the dial and then rotate the dial until the desired central
heating zone is shown then press the dial again, rotate the dial
until the Time program is highlighted and then press the dial
again. The following screen will be shown:-
Heating
Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
Sunday
Rotate the dial until the desire day for setting is shown and
then press the dial.
The following screen will be shown:
Monday
Set time program
06:00 to 08:00
Copy
Move the highlighted area to the time you wish to change using
the dial and press the dial, then rotate the dial to change the
time and press the dial to save.
08:32
20.0ºC
20.0ºC
3.1ºC
0l/min
0%
Off
Off
CH
Off
08:32
Heating zone 1
40.0ºC
40.0ºC
--ºC
08:32
Zone 1
Back
08:32
Zone 1
Back
51
Advertisement
Table of Contents
