Nortel CallPilot User Manual page 96

96 Chapter 8 Replacing basic chassis components
Step
1
2
3
4
Copyright © 2007, Nortel Networks
.
Action
Prepare the server for rear system fan replacement as follows:
a. Shut down the server, and then disconnect the power and
peripheral device cables.
b. Place the server on its side.
c. Remove the side cover.
For instructions, see"Preparing the server for hardware maintenance"
(page 81).
WARNING
Failure to follow the procedures
hardware maintenance" (page 81)
shock or equipment damage.
Lift the tab on the bracket that holds the fan in place.
Angle the fan towards the interior of the server, and then lift it away
from its slot.
Disconnect the power cable of the fan connector from the server's
motherboard.
Nortel CallPilot
703t Server Maintenance and Diagnostics
NN44200-702 01.03 Standard
5.0 3 April 2007
in"Preparing the server for
can result in electrical
Nortel Networks Confidential