Powering Up The Router; Prerequisites; Verifying A Successful Installation - Nortel Secure 4134 Quick Start Manual

46 Installing the Secure Router 4134 chassis and hardware components

Powering up the router

Use the procedure in this section to power up your Secure Router 4134.

Prerequisites

•
•
•
Procedure steps
Step
1
2
3
4
5
If status LEDs do not illuminate green, see Nortel Secure Router 4134 —
Troubleshooting (NN47263-700).

Verifying a successful installation

Use the information in this section to verify that you have successfully
installed the Secure Router 4134 and its components.
If any LED behavior indicates failure or is suspect, see Nortel Secure Router
4134 — Troubleshooting (NN47263-700).
In a normal power-up sequence, the following events occur:
1. When you power up the router, the fans start and the Secure Router
Copyright © 2007, Nortel Networks
.
Ensure all installation procedures are complete.
Ensure an operator console is connected to the Secure Router 4134.
Ensure the Secure Router 4134 is connected to a power source.
Action
For an AC power supply, press the rocker switch located on the
power supply to the on position (|).
On a DC power supply, ensure the DC power source is on.
Verify that the power supply status LED for each power supply is
green.
Verify that the fan status LED is green.
Verify that the air flows from the cooling fans through the vents of
the chassis.
The fan tray red (fail) LED can illuminate briefly while the fans power
to operational speed.
4134 performs a self-test.
Nortel Secure Router 4134
NN47263-100 01.01 Standard
10.0 16 July 2007
—End—
Quick Start