Installing A Filler Panel In A Switching Fabric Module Slot - H3C S12500X-AF Series Quick Start Manual

Figure 21 Removing the switching fabric module from the protection box (S12516X-AF
switching fabric module)
(1) Five screws to secure the protection box to the switching fabric module
(3) Hold the protection box to disengage it from the connector side of the switching fabric module
Figure 22 Installing a switching fabric module (S12516X-AF switch)
(1) Push the switching fabric module slowly into the slot
(2) Rotate the ejector levers inward until the spring clips lock the ejector levers in place

Installing a filler panel in a switching fabric module slot

The switch comes with empty switching fabric module slots. Install a filler panel in a switching fabric
module slot if you are not to install a switching fabric module in it.
24
(2) Loosen the captive screws