Table of Contents
Advertisement
21
Maintaining Combustor Burn-Off
WARNING:
The bypass control becomes hot
during operation - use gloves or a
tool to prevent burns.
This stove uses a combustor to
increase heat transfer to the room
and reduce emissions.
Follow the directions below to utilize the combustor to its fullest potential.
•
Keep the by-pass open (pulled out) until the stove becomes hot (approximately 15 to 30 minutes).
•
Close the bypass (pushed in) when the stove is hot.
•
Keep the bypass closed (pushed in) while the stove is operating, except when reloading.
How to Check if your Combustor is Working
A combustor temperature probe is included with the
fireplace to monitor the combustor. After the bypass
is engaged, the combustor temperature should rise,
showing combustor operation. Combustor
temperatures over 500° F (260° C) indicate the
combustor is working and igniting unburnt fuel.
The combustor can also be viewed through the glass
from below. You will notice the combustor glowing
red when the combustor is working effectively.
© Travis Industries
Operation
1/12/2023 - 1574
Press this
ON/HOLD
button to view
the temperature.
Endeavor NexGen-Hybrid
Advertisement
Table of Contents
