Table of Contents
Advertisement
14
Stove Installation
Alcove Installation Requirements
Whenever the stove is placed in a location where the ceiling height is less than 7' (2134mm) tall, it is
considered an alcove installation. Because of the reduced height, the special installation requirements
listed below must be met.
The Chimney connector and chimney must be one of the following types:
AMERI-TEC model DCC with model HS chimney
DURAVENT model DVL with DURATEC or DURA-PLUS chimney
GSW Super Chimney Twenty-One connected directly to appliance
I.C.C. Excel (2100-2 Can.) (103-HT USA) chimney with ULTRABlack connector
METALFAB model DW connector with TG chimney
OLIVER MACLEOD PROVENT model PV connector with model 3103 chimney
SECURITY model DP or DL connector with SECURITY model ASHT or S2100 chimney
SELKIRK METALBESTOS model DS connector with model SSII chimney
Standard Masonry Chimney with a positive connection (full reline) using any one of the above listed connectors
NOTE: Reduced clearance connectors may not connect to the flue collar – an appliance adapter may be required.
Alcoves are classified as combustible or non-combustible. Non-combustible alcoves must have walls
and a ceiling that is constructed of 3-1/2" (89mm) thick of a non-combustible material (brick, stone, or
concrete. This non-combustible material must be spaced and ventilated at least 1" (25mm) off of all
combustible materials (walls, ceiling, etc.) to allow air to move around the non-combustible walls and
ceiling. All other alcoves are considered combustible. The clearances below must be met:
© Travis Industries
(for qualified installers only)
1" (25mm)
Min.
IDB1121
1/12/2023 - 1574
Non-combustible alcove
construction (on walls
and ceiling) - see the
explanation above.
Ventilated
air space
Min. 3 1/2"
(89mm) non-
combustible
material
Non-combustible
reinforcer
Endeavor NexGen-Hybrid
Advertisement
Table of Contents
