Table of Contents
Advertisement
26
Optional Blower Operation
The blower will turn on once the stove is up to temperature. This is typically 15 to 30 minutes after
starting the fire. Follow the directions below to alter the blower speed.
NOTE: We recommend operating the blower at low speed for an overnight burn and high speed for a high burn.
The blower may be used to affect heat output (i.e.: to reduce heat output, turn the blower down).
Route the power cord in a location where it will not come in contact with the appliance or become hot.
Re-Loading the Stove
Use gloves when reloading wood.
Follow the directions below to minimize smoke spillage while re-loading the stove.
1. Open the air control all the way (pull out).
2. Open the bypass all the way (pull it out) if needed to prevent smoke spillage.
3. Open the door slightly. Let the airflow inside the firebox stabilize before opening the doors fully.
4. Load wood onto the fire.
Overnight Burn
This stove is large enough to accommodate burn times of up to 10 hours. Follow the steps below to
achieve an overnight burn.
1. Move the air control to high burn and let the stove become hot (burn for approximately 15 minutes).
2. Load as much wood as possible. Use large pieces if possible.
3. Let the stove burn on high for 15 minutes to keep the stove hot, and then turn the air control to low.
4. In the morning, the stove should still be hot, with embers in the coal bed. Stir the coals and load small pieces
of wood to re-ignite the fire, if desired.
Differences in chimney height and draft may lower overall burn times.
© Travis Industries
Operation
1/12/2023 - 1574
Endeavor NexGen-Hybrid
Advertisement
Table of Contents
