Table of Contents
Advertisement
UNDERCARRIAGE
REASSEMBLY
REMARK
Callouts from exploded and cross section views correspond with callouts
in following steps.
1. Install new o-ring (7) into mounting support and coat with amber grease.
Apply a thin coat of "Never Seez" to shaft bore.
2. Install shaft (3) into mounting support (8) aligning pin hole with dowel.
Secure shaft to support with roll pin (9).
3. Coat thrust washer (5) with a light film of clean oil and install on shaft up
against support.
4. Install new seal half (6) into support. Refer to METAL TYPE FACE
SEALS in this section.
5. Position front idler (1) on work table as shown. Install new seal half (6)
into front idler. Refer to METAL TYPE FACE SEALS in this section. Apply
a light film of clean oil to each bushing.
14 - 18
FRONT IDLER
Hide quick links:
Advertisement
Chapters
Table of Contents
