Komatsu D32E-1 Shop Manual page 347

REASSEMBLY
1. Planet Gear Carrier
2. Retaining Ring
3. Planet Gear
4. Needle Bearing Kit
5. Needle Bearing Spacer
6. Planet Gear Shaft
7. Thrust Washer
8. Ring and Pinion Set
9. Retainer Plate
10. Ring Gear Carrier
11. Tapered Roller Bearing
12. Bearing Carrier
13. Carrier Bushing
REMARK
Callouts from exploded and cross section views correspond with
callouts in following steps.
REMARK
Thoroughly coat all moving surfaces with clean oil. Refer to
OPERATION & MAINTENANCE MANUAL for proper type and
grade.
1. Secure bevel gear (8) to gear carrier (10) with two bolts.
Lubricate remaining bolts with clean engine oil and install.
Remove two securing bolts and lubricate and reinstall. Torque
bolts to 75 NCm (55 lbf ft).
2. Position carrier assembly in press with bevel gear end down.
Place bearing cup (11) in carrier. Using suitable pusher plate,
apply press and install cup flush with edge of carrier.
3. Remove assembly from press and position with bevel gear end
up. Install one planet carrier assembly with retaining ring end up.
14. Carrier Shim
15. Sun Gear
16. Retaining Ring
17. Clutch Disc
18. Brake Disc
19. Apply Shoe
20. Eccentric Shaft
21. Thrust Washer
22. Left Steering Arm
23. Right Steering Arm
24. Left Brake Arm
25. Right Brake Arm
26. Retaining Ring
27. Back Up Shoe
28. Arm Return Spring
29. Adjustment Screw
30. Screw Lock Plate
31. Adjustment Screw
32. Left Mounting Plate
33. Dowel Pin
34. Needle Bearing
35. Right Mounting Plate
36. Dowel Pin
37. Needle Bearing
38. Plate Mounting Spacer
39. Spring Pin
STEERING DRIVE
40. Long Connector
41. Seal Flange
42. Connector Boot
43. Boot Clamp
44. Steering Cylinder
45. Brake Rod Clevis
46. Brake Actuator Bar
47. Brake Equalizer Bar
48. Clevis Pin
49. Pivot Pin
50. Frame Bearings
51. Brake Cylinder
52. Cylinder Fitting
7E - 51