IP address pool configuration
Contents
Introduction
IP address pools
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IP address pools. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Proxy ARP and tunnel-to-tunnel traffic . . . . . . . . . . . . . . . . . . . . . . . .
This section describes how to configure an IP address pool and enable proxy
ARP and tunnel-to-tunnel traffic.
Use Procedure 5 to configure an IP address pool.
Procedure 5
Configuring an IP address pool
1
In the Contivity Secure IP Services Gateway window, select SERVERS >
User IPaddr.
The User IPaddr window appears, as shown in Figure 11 on
WLAN Handset 2212
Installation and Configuration for VPN
Page 33 of 62
33
33
35
page 34
.