Table of Contents
Advertisement
3
Audio input connector — If desired, plug an analog audio input into the transmitter
via this stereo mini jack connector.
NOTE: The analog audio input on this connector is in
addition to the digital audio that may be embedded
in the DVI input.
See the figure at right to identify the connector tip,
ring, and sleeve when you are making connections
for the transmitter from existing audio cables.
•
A mono audio connector consists of the tip
and sleeve.
•
A stereo audio connector consists of the tip,
ring, and sleeve.
4
RS-232 and IR connector — Connect a serial RS-232 signal, a modulated IR signal,
or both to this 3.5 mm, 5-pole captive screw connector for bidirectional RS-232 and
IR communication (see
connector).
5
DTP Output RJ-45 connector — Connect one end of a TP cable to this RJ-45
female connector on the transmitter. Ensure the opposite end of this cable is connected
to the receiver DTP Input RJ-45 connector (see figure 3,
ATTENTION:
Do not connect this device to a telecommunications or computer
data network.
Ne connectez pas cet appareil à un réseau de télécommunications
ATTENTION :
ou de données informatiques.
NOTE: See
TP cable termination and recommendations
wire the RJ-45 connectors and for detailed NOTES.
Signal LED — Indicates the unit is receiving a TMDS clock signal on the DVI input.
Link LED — Indicates a valid link is established between the units on the DTP input
and output cable.
6
Power input connector — Plug the included external 12 VDC power supply into
either this 2-pole connector or the power input connector on the receiver (
6). See
Power supply wiring
NOTES:
One power supply is included with the transmitter and normally can power
•
both units.
•
If you have removed the ground jumpers (see
on page 12) because of ground potential differences, one DTP DVI 330 unit
cannot remotely power the other unit. Each unit requires a local power
supply.
DTP DVI 4K 330 Transmitter and Receiver • Installation and Operation
RS-232 and IR connector wiring
on page 8 to wire the connector.
Tip (+)
Ring (-)
Sleeve ( )
3.5 mm Stereo Plug Connector
(balanced)
on page 9 to wire the
).
1
on page 6 to properly
on page
5
Disconnecting the Ground
4
Advertisement
Table of Contents
