Table of Contents
Advertisement
Platform Extension
The machine is equipped with a mechanically extendable
deck, which adds 0.9 m (3 ft) to the front of the platform,
giving the operator better access to worksites. To extend
the deck, pull out handle from latch and swing up, then
use the handles and handrail to push the extendable deck
out. To retract the deck, pull out the handles from latch
and swing up, use the handles and handrail to pull and
retract the deck. Be sure the lock pin is locked in place
after the deck is retracted. Maximum capacity of the deck
extension is 120 kg (250 lbs).
DO NOT 'LIFT DOWN' WITHOUT COMPLETELY RETRACTING THE
PLATFORM EXTENSION.
4.5 STEERING
To steer the machine, the thumb operated steer control
switch on the controller handle is positioned to the right
for traveling right, or to the left for traveling left. When
released, the switch will return to the center-off position
and the wheels will remain in the previously selected posi-
tion. To return the wheels to the straightened position, the
switch must be activated in the opposite direction until the
wheels are centered.
4.6 TRAVELING
DO NO T DRIV E WI T H P LATF ORM RA I S E D EXC EPT ON A
SMOOTH, FIRM AND LEVEL SURFACE FREE OF OBSTRUCTIONS
AND HOLES.
TO AVOID LOSS OF TRAVEL CONTROL OR UPSET ON GRADES
AND SIDESLOPES, DO NOT DRIVE MACHINE ON GRADES
EXCEEDING THOSE SPECIFIED ON CAUTION PLACARD AT PLAT-
FORM.
NOTE: The 400CRT is equipped with a drive cutout switch
that cuts out the drive function at 9.1m (30 ft).
3121803
SECTION 4 - MACHINE OPERATION
Traveling Forward
1. With the engine running, place the power select
switch to platform.
2. Position the applicable emergency stop Switch to
the on position.
3. After starting engine press the drive select switch
and move the joystick forward and hold for the dura-
tion of travel. Drive speed is determined by the dis-
tance the control handle is moved from the center
off position. For additional drive speed, position the
high speed switch to high while operating in the
drive forward mode.
Traveling in Reverse
1. With engine running, position the power select
switch at the ground control station to platform.
2. Position the emergency stop switch at the platform
control station to the on position.
3. Press the drive switch and move the drive controller
rearward (reverse) and hold for the duration of
travel. Drive speed is determined by the distance the
control handle is moved from the center off position.
Do not activate the high engine speed switch when
traveling in reverse.
– JLG Lift –
4-3
Advertisement
Table of Contents
