Table of Contents
Advertisement
Basic safety information
2.3 Intended use
The safety measuring system can be used for the detection of angular movement and
processing of measured data for a downstream evaluation device in systems in which
the protection goals of "Protection of speed" and "Protection of direction of
movement" must be safely achieved. The complete processing chain of the safety
function must then satisfy the requirements of the applied safety standard.
The safety measuring system may only be used in safety applications in conjunction
with an evaluation device certified according to the applied safety standard.
The system manufacturer must check that the characteristics of the measuring system
satisfy his application-specific safety requirements. The responsibility or decision
regarding the use of the measuring system lies with the system manufacturer.
Intended use also includes:
●
observing all instructions in this operating manual,
●
observing the nameplate and any prohibition or instruction symbols on the
measuring system,
●
observing the operating instructions from the machine/system manufacturer,
●
operating the measuring system within the limit values specified in the technical
data,
●
ensuring that the fail-safe evaluation device fulfils all required safety functions,
●
observing and using the checklist in the appendix,
●
safe mounting (form closure) of the measuring system to the driving axis, also see
chapter
2.4 Non-intended use
WARNING!
Danger of death, physical injury and damage to property in case of non-
intended use of the measuring system!
Operating Manual PSEN enc sincos/HTL
1005022-EN-01
Mounting
➢
The following areas of use are especially forbidden:
in environments where there is an explosive atmosphere,
-
for medical purposes
-
Seite 10 von 38
Advertisement
Table of Contents
