Setting The Timer - Radiodetection Smart Interrupter 50AG User Manual

Antenna
Fault (flashing symbol)-replace antenna
Position (steady symbol)-move Smart Interrupter to a
better GPS reception area
Signal level
Minimum signal strength / Maximum signal strength
Synchronization being determined
Synchronization to GPS OK last time
No synchronization to GPS last time ("free running")
Timer Mode
Note: The Smart Interrupter clock is automatically adjusted
every time a GPS signal is received. The clock automatically
adjusts to local time.
You can instruct a GPS Smart Interrupter to activate at a
certain time and de-activate at another.
Press the timer button. The Use Timer screen is
displayed.
Press the left/right arrow buttons to select either Yes or No.
If you select No the unit reverts to the main screen and the
timer will not operate. If you select
Yes the timer screen is displayed.
If there is no GPS signal or the GPS antenna is not
connected, the timer cannot be enabled and the following
screen is displayed.
Press OK to return to the previous screen without setting
the timer.

Setting the timer

Press the timer button and use the left/right arrows to select Yes.
The following screen is displayed:
Press the left/right buttons to change the set time. Press OK
to toggle from start time to stop time. Once the start/stop
times have been set press OK to
display the Local Time Now screen.