Multifunction precision cable and pipe locator (15 pages)
Summary of Contents for Radiodetection PCMx
Page 1
PCMx ™ Pipeline Current Mapper system User Guide 用 户 指 南 Bedienungsanleitung Руководство пользователя Guía del usuario Guide de l’utilisateur 90/UG105INT/03...
Page 2
It also contains important safety information and guidelines registering their products within 3 months of purchase. and as such should be read in its entirety before attempting to operate the PCMx Registration is carried out using the PCM Manager PC software which can be receiver and transmitters.
Page 3
21. Sensitivity readout / Log number. from the transmitter. 22. Volume level. When the PCMx has the magnetometer 23. Current Direction or Fault Find arrows foot attached, a reverse arrow, (pointing GPS active, seeking satellite lock (see note below).
Page 4
Tx-150 Tx-25 transmitters The Tx-150PCM and the Tx-25PCM Transmitter controls PCM & are constant current transmitters which transmit a 4Hz mapping frequency Frequency Select suitable for pipeline surveys. The rotary switch selects the applied The Tx-150PCM (150W) allows for long frequencies as follows: range signal detection of up to 30km ELF Transmission lines...
Page 5
LED provides the battery pack charging The PCMx can also be used with a 2. Use the keys to scroll condition, it is probable that the voltage status as follows: Radiodetection locating transmitter.
If your selection and return to the main a compatible application such as • BT: Enable, disable, reset or pair the PCMx is set to the incorrect power operation screen. PCM Manager or Bluetooth enabled Bluetooth connections. Also defines the frequency, the user will have difficulty transmitters.
Page 7
45m / 150 feet away 1. Use the key to match the frequency 2. Hold the PCMx upright and near to and an anode bed for a suitable ground. from the pipe. To achieve a suitable mode of the receiver to the operating the ground.
Page 8
If a suspected fault 3. Press the key to enter the GPS key. The PCMx can store up to 10,000 displayed and the receiver will revert to location has been identified from a menu.
Page 9
GPS devices. After installing the software described previously. on your mobile device select the PCM 2. Set the PCMx transmitter to either Manager icon. ELCD or LFCD mode. Prepare the PCMx receiver to pair by 3.
RD8100, eCert, iLOC, TruDepth, SideStep, SideStepauto, PCM Manager, Peak+, SurveyCERT, StrikeAlert, CALSafe, Current Direction. The Bluetooth word, mark and logos are registered trademarks of Bluetooth SIG, Inc. and any use of such trademarks by Radiodetection is under license. Due to a policy of continued development, we reserve the right to alter or amend any published specification without notice.
Page 11
RD8100, eCert, iLOC, TruDepth, SideStep, SideStepauto, PCM Manager, Peak+, SurveyCERT, StrikeAlert, CALSafe, Current Direction. The Bluetooth word, mark and logos are registered trademarks of Bluetooth SIG, Inc. and any use of such trademarks by Radiodetection is under license. Due to a policy of continued development, we reserve the right to alter or amend any published specification without notice. This document may not be copied, reproduced, transmitted, modified or used, in whole or in part, without the prior written consent of Radiodetection Ltd.
Need help?
Do you have a question about the PCMx and is the answer not in the manual?
Questions and answers