Table of Contents
Advertisement
Install Turbo Assembly
1. Park tractor on a hard, level surface such as a concrete
floor. Engage parking brake, disengage PTO, and stop
engine.
2. Install new pulley assembly (A, Figure 5) with large
diameter pulley down.
3. Insert key (h) and belleville washer (g) with concave
side facing Down. Secure with nut (f). Torque to 65-75
lbs. ft. (88.1-101.6 Nm).
Figure 5
4. Remove wooden block in the mower deck.
5. Re-install drive belt (d, Figure 6) onto the lower pulley
of the pulley assembly (A). Roll belt downward while
rotating pulley assembly until belt is in place.
Figure 6
f
g
h
A
d
A
6. On the inside of discharge opening, insert carriage bolt
(B, Figure 7) through slot and secure with retainer (C).
Figure 7
7. Rotate deflector and place in the upright position.
8. (Assistance maybe needed to perform this step). Place
turbo (E, Figure 8) onto discharge opening, aligning
deck tabs (j) with turbo tabs (k). Belt (l) needs to slide
through opening between deflector and deflector
bracket. Ensure carriage bolt (B) on deck aligns with slot
(m) on turbo.
Figure 8
7
B
j
k
l
E
m
C
E
B
Advertisement
Table of Contents
