Install New Pulley Cover - Briggs & Stratton 1696783 Operator's Manual

9. On right side, align holes of deck tab (o, Figure 9) with
holes of turbo tabs (p) and secure with snapper pin (F).
10. On left side, pull back on idler arm (n). Align holes
of deck tab with holes of turbo tabs and secure with
snapper pin.
o
p
F
Figure 9
11. Install turbo belt (l, Figure 10) onto top pulley of pulley
assembly (A) using belt tension arm (n) for assistance.
A
l
Figure 10
12. Ensure belt is routed as shown in Figure 11.
Figure 11
n
13. Secure turbo to deck with flat washer (G, Figure 12),
lockwasher (H) and knob (
Figure 12

Install New Pulley Cover

1. Align notches of new pulley cover (D, Figure 13) with
taptite screws in deck plate. Tighten tapetites (a).
n
D
Figure 13
8
l
).
] [
G
H
][
a
A
n