Installation - Emos P56201 Manual

INSTALLATION

Attention:
Before changing the thermostat, disconnect the heating system from the mains
power in your home. This will prevent potential injury by electric current.
Installing the Thermostat
1. Remove the rear cover of the thermostat (see fig. 2).
2. Mark the spots for holes.
3. Drill two holes, carefully insert the plastic wall plugs into them and use two
screws to fasten the rear thermostat cover.
4. Connect the wires to the labelled terminals according to the wiring diagram
found under the cover.
5. Complete the installation by fitting the thermostat onto the mounted rear
cover.
Placement of the Thermostat
The placement of the thermostat (transmitter unit) significantly affects its
functioning.
Choose a location where members of the family spend most of their time,
preferably near an inside wall where air circulates freely, with no direct sunlight.
Do not place the thermostat in the vicinity of heat sources (such as TV sets, radi-
ators, fridges), or close to a door. Failure to comply with these recommendations
will prevent proper control over room temperature.
Wiring Diagram:
Pump/Motorised Valve Connection Diagram
Pump/
valve
Floor Heating Connection Diagram
Connected
device
16