Troubleshooting; When The Storage System Does Not Start - HP StorageWorks MSA500 G2 User Manual

Troubleshooting

In this section
When the storage system does not
Diagnostic steps............................................................................................................................76
Recognizing hard drive failure
Factors to consider before replacing hard
Automatic data recovery
Drive failure in a NetWare environment
Display messages..........................................................................................................................85

When the storage system does not start

If the storage system does not start:
1. Be sure that the attached server and monitor are working properly.
2. Be sure that the storage system is plugged into working outlets.
3. Be sure that the power source is working properly:
- Check the status using the system power LED on the front panel.
- Be sure that the Power On/Standby button was pressed firmly.
4. Be sure that the power supplies are working properly:
Check the status using the power supply LEDs ("Power supply/blower
assembly LEDs" on page 14).
5. Restart the system.
6. Check the storage system for the following normal power-up sequence to be
sure that the system meets the minimal hardware requirements and is
powered up during normal operations:
a. The front panel power LED turns from off (standby/off) to on (solid
start........................................................................................75
.....................................................................................................78
drives..........................................................................81
(rebuild)................................................................................................82
......................................................................................84
IMPORTANT: If the system does not restart, proceed to "Diagnostic
Steps (on page 76)."
green).
75