Using The Ez165 & Ez365 - Martindale Electric EZ165 Instruction Manual

Socket tester

Hide thumbs Also See for EZ165:

Table of Contents

Pulsed tone increasing to

continuous tone

3.3 Using the EZ165 & EZ365

Plug the EZ165 or EZ365 into the socket to be tested.

The wiring test is performed first. As the test is performed, the

lower LED's flash orange in sequence, until the test is complete

and the result is then displayed. Compare the status of the flashing

indicators with the front decal or with figures 1, 2 & 3 in sections

3.3.1 and 3.3.2.

If the wiring test is successful, then the loop impedance test is

performed. The top row of LED's will flash orange in sequence

until the test is complete. When the test is complete, the result

is displayed. If the wiring test detected a fault, then the loop

impedance test is not performed.

If the EZ165 / EZ365 does not power up and none of the

LED's illuminate this could mean that the wiring is incorrect,

or the mains voltage is less than 135V and investigation of the

wiring is required. In such circumstances verify the EZ165 /

EZ365 in a known correctly wired socket to confirm the need

for investigation.

RCD trip test will be activated in 2

seconds

Table of Contents

Ez365