At+Cr Service Reporting Control - Nokia PremiCell Manual

List of at commands

Table of Contents

COLP information:

When the presentation of COLP on the DTE is enabled (and the

called subscriber permits), the +COLP:<number>,<type>[,,,<al-

pha>] response is returned before any +CR or V.25ter responses. Re-

fer to AT+CLIP for descriptions of the response parameters.

AT+CR Service Reporting Control

This command controls whether or not the result code +CR:<serv>

is returned from the data adapter to the computer. If enabled, the

result code is transmitted at the point during the connect negotia-

tion during which the data adapter has determined the speed and

quality of service to be used, before any error control or data com-

pression reports are transmitted, and before any final result code

(e.g. CONNECT) is transmitted.

Syntax:

AT+CR=[<mode>] Set service reporting control mode.

AT+CR?

<mode>.

AT+CR=?

Parameters:

<mode>

<serv>

ASYNC

REL ASYNC

Query current setting. Response is +CR:

Show supported values. Response is +CR: (0,1).

disable reporting

enable reporting

asynchronous transparent

asynchronous non-transparent

Table of Contents