Rip Fence - Kobalt KT10152 Manual

BEFORE OPERATING

RIP FENCE

• To reduce the risk of injury, always make sure the rip
fence (T) is parallel to the blade (W) before beginning
any operation. Using Rip Fence
1. Make sure both the front and rear side of fence 10 in
away from the blade.
2. If not accuracy, use the 4 mm hex wrench to loose the
screws for both front & rear tabs.
3. Adjust the fence to proper position and make sure the
fence parallel to the blade, then tighten the screws for
tabs.
4. Place the fence on the silver tabs (read the silver
scale, the pointer indicates 10 in).
5. For Black tabs (right 0 in ~ 10 in) and Yellow tabs (left 0
in ~ 17 in), repeat the same adjustment as above.
For thin materials use the fence on the left of the
blade. Fold down the thin fence to allow use of blade
guard. Subtract 2 inches from the scale for accurate
measurement.
WARNING
3
28
kobalttools.com