Sliding Fence; Sliding Carriage System; Miter Detent Override - Kobalt NEXT GENERATION OF TOUGH TOOLS SM2507LW User Instructions

SLIDING FENCE (FIG. 30)
WARNING
!
The sliding fence must be extended when
making any bevel cut. Failure to extend the
sliding fence will not allow enough space for
the blade to pass through which could result in
serious injury. At extreme miter or bevel angles
the saw blade may also contact the fence.
Unlock the fence cam locking lever (1) by
●
pushing it back, AWAY from the fence.
Extend the fence (2) by sliding it out to
●
match the degree of the bevel cut. Lock
the fence cam locking lever by pulling it IN
toward the fence. NOTE: When transporting
the saw, always secure the sliding fence in
the collapsed position and locking it.
SLIDING CARRIAGE SYSTEM (FIG. 31)
CAUTION
!
To reduce the risk of injury, return carriage
to the full rear position after each crosscut
operation.
For chop cutting operations on small
●
workpieces, slide the cutting head assembly
completely toward the rear of the unit and
tighten the carriage lock knob (1).
To cut wide boards up to 12 in., the carriage
●
lock knob must be loosened to allow the
cutting head to slide freely.
MITER DETENT OVERRIDE (FIG. 32)
The miter detent override allows for the table
to be micro adjusted, disengaging the positive
detent stops feature. When a required miter
angle is close to a positive detent stop, this
override prevents the wedge on the miter arm
from slipping into that detent slot on the base.
Unlock the miter table by turning the miter
●
handle (1) counterclockwise.
While holding the miter handle (1), pull
●
upward on the positive stop locking lever (2)
and press the override lock IN (3), then
release the positive stop locking lever (2)
while holding the override lock IN. The
detent override is now engaged.
Turn the table to the desired angle, secure
●
the table by turning the miter handle (1)
clockwise.
To disengage the detent override, loosen the
●
miter handle (1) and pull the positive stop
locking lever (2) up. This will release the
override lock and the table will now stop at
the positive detent angles.
30
1
2
31
32
3
kobalttools.com
30
1
2
1