Blade Guard Installation - Kobalt KT10152 Manual

ASSEMBLY INSTRUCTIONS

BLADE GUARD INSTALLATION

To install blade guard:
1. With front of blade guard (A) raised, hook back end
of guard onto rear slot of riving knife (X).
2. Push front down until it is parallel to table. Lock
blade guard (A) in place by pushing lever down.
3. If blade guard (A) is not parallel to table, riving knife
(X) is not in raised (through cut) position. Raise
and lower each side of the blade guard to verify
free movement of the guard system. Be sure the
guard system can be raised enough to clear your
workpiece.
Note: Blade alignment with riving knife can be adjusted.
See: Checking and Aligning Riving Knife and
Saw Blade, page 41. Check the blade guard (A) for
clearances and free movement.
24
kobalttools.com