Product Specifications - Kobalt KT10152 Manual

10-in table saw

Hide thumbs Also See for KT10152:

Manual (152 pages)

100

101

Table of Contents

Available languages

POWER CONNECTION

SPEED AND WIRING

• The no-load speed of this tool is approximately 5,000 RPM. This speed is not constant and

decreases under a load or with lower voltage.

• For voltage, the wiring in a shop is as important as the motor's horsepower rating. A line intended

only for lights cannot properly carry a power tool motor. Wire that is heavy enough for a short

distance will be too light for a greater distance. A line that can support one power tool may not be

able to support two or three tools.

DOUBLE INSULATION

To reduce the risk of electric shock, this equipment has a polarized plug (one blade is wider than the

other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,

reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.

DO NOT change the plug in any way.

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package

contents list and hardware contents list. If any part is missing or damaged, DO NOT attempt to

assemble the product.

Estimated Assembly Time: 45 minutes

Tools Required for Assembly (not included): Sharp knife or utility knife to cut carton, Phillips

screwdriver, flathead screwdriver, combination square, framing square, tape measure or ruler,

13 mm open end wrench, 10 mm open end wrench or adjustable wrench, 5 mm Allen wrench.