ST STM32Cube Quick Start Manual page 31

Plug USB
connector
and open
Tera Term *
Enter set_neai timer [t] or
set_neai signals [n] to customize
your learning phase **
Start learning, detecting
or classifying by specific
commands
*Be careful, it's strongly recommended plug/unplug USB connector only when the library
is not running: NOT plug/unplug USB during learning/detecting/classifying
The proper workflow
**
This step is optional but
remember that by default:
- ISM330DHCX is active
with ODR = 3332 Hz and
FS = 2 G
- Learning/Detecting
phases will end when
you'll push stop button
(Time/Signals parameter
is initialized to zero)
Stop learning, detectingor
classifying automatically
or pushing escape button
It's strongly recommended to
setup your sensor according to
dataset used to generate NEAI
library
31
phase.