Table of Contents
Advertisement
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1
Figure 18. Installing SAS 4-port host interface card
1 Retaining thumbscrew
v
2 Filler handle
v
3 Host interface card
v
4 Catch slot
v
2. From inside the canister, grasp the filler handle 2 and slide the filler plate
toward the center of the canister to disengage the plate from the catch slot.
3. Remove the filler plate.
4. Insert the host interface card 3 into the canister as shown in Figure 18.
5. Align the mounting bracket of the host interface card with the inside of the
host interface card aperture at the rear of the canister, ensuring that the tab at
the end of the faceplate is aligned with the catch slot.
6. Align the connecting edge of the host interface card with the slot in the host
interface card connector inside the canister.
7. Apply pressure to the opposite edge of the host interface card to push the card
into the host interface card connector.
8. Check that the host interface card is installed squarely in its slot and tighten the
retaining thumbscrew 1 .
4
2
3
Chapter 2. Installing the hardware
27
Advertisement
Table of Contents
