Table of Contents
Advertisement
– The enclosures themselves. Access is required to the hardware for servicing
and for safely removing and replacing components using two or more people.
Procedure
To install the cables, complete the following steps.
1. Using the supplied SAS cables, connect the control enclosure to the first
expansion enclosure as shown in Figure 26 on page 36.
a. Connect SAS port 4 of the left node canister in the control enclosure to SAS
port 1 of the left expansion canisters in the first expansion enclosure.
b. Connect SAS port 4 of the right node canister in the control enclosure to
SAS port 1 of the right expansion canisters in the first expansion enclosure.
Chapter 2. Installing the hardware
35
Advertisement
Table of Contents
