Identification; Pc Communication; General Information - Labgear DAT103 Operating Manual

Calib table. Calibration table status.
This function checks calibration table. If no errors detected, the Ok status is displayed.
If an error has been detected, the Error status is displayed. In this case, please contact
the service center.
ChPlan mem. Channel plan memory status.
DataLog mem. Data log memory status.
This function shows the free memory in percent for each memory type.
Devices. Internal devices status.
This program checks the condition of the Analyzer components. If no errors detected,
the Ok status is displayed. If an error has been detected, the Error status is displayed. In
this case, please contact the service center.

4.7 Identification

The icon in the Service menu refers to this mode. The Identification function
allows you to determine the Analyzer model, its serial number, modification and firmware
version, channel template name. The screen view is represented in the Figure 4.7.1.
Your DAT103 data are displayed in the upper part of the screen:
a) Model – Analyzer model;
b) HW ver. – Analyzer hardware version;
c) SW ver. – Analyzer firmware version;
d) S/N – Analyzer serial number.
In the lower part of the screen, you will find the name of the channel template, which is
selected in Setup mode (Section 4.5).

4.8 PC communication

4.8.1 General information

You can operate your DAT103 via PC. For connection to PC use USB
bottom panel of the Analyzer. The DAT Tools software allows the following:
a) measurement of video carrier level, C/N ratio and V/A ratio for analog channels and
channel power for digital channels;
b) measurement of spectrum within scaleable frequency band (from 45 to 900 MHz);
c) measurement of DVB-T signal reception quality;
d) viewing and creating data log pages;
e) editing of channel plans;
26
Figure 4.7.1
on the