Safety Recommendations - Cisco Catalyst 8300 Series Hardware Installation Manual

Safety Recommendations

Figure 79: PIuggable Interface Module in a Cisco 8300-2N2S-4T2X|6T
1 Pluggable interface
module
•
•
•
•
•
•
•

Safety Recommendations

To prevent hazardous conditions, follow these safety recommendations while working with this equipment:
• Keep tools away from walk areas where you or others could fall over them.
• Do not wear loose clothing around the router. Fasten your tie or scarf and roll up your sleeves to prevent
• Wear safety glasses when working under any conditions that might be hazardous to your eyes.
• Locate the emergency power-off switch in the room before you start working. If an electrical accident
• Before working on the router, turn off the power and unplug the power cord.
• Disconnect all power sources before doing the following:
• Do not work alone if potentially hazardous conditions exist.
• Always check that power is disconnected from a circuit.
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
108
Safety Recommendations, on page 108
Tools and Equipment Required During Installation, on page 109
Remove Cisco Catalyst Pluggable Interface Module, on page 109
Install a Cisco Catalyst Pluggable Interface Module, on page 109
Configuring a Pluggable Interface Module, on page 110
RF Band Mapping for Antenna Ports (For P-5GS6-GL only), on page 112
Attaching the Antennas, on page 113
clothing from being caught in the chassis.
occurs, shut the power off.
• Installing or removing a router chassis
• Working near power supplies
Cisco Catalyst Pluggable Interface Module