Install Internal Components and Field Replaceable Units
Figure 69: USB Memory Stick
Note
You can insert or remove the memory stick whether the device is powered on or not.
1
2
3
What to do next
This completes the USB Flash memory installation procedure.
Remove and Install an M.2 USB|NVMe Module
This section describes installing and replacing an M.2 USB|NVMe module on the Cisco Catalyst 8300 Series
Edge Platforms.
Prevent Electrostatic Discharge Damage
The M.2 module is sensitive to electrostatic discharge (ESD) damage, which can occur when electronic cards
or components are handled improperly. ESD results in complete or intermittent failures.
To prevent ESD damage, follow these guidelines:
• Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
USB Type C (3.0) (USB 1)
USB stick
USB Type A (3.0) (USB 0)
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
Remove and Install an M.2 USB|NVMe Module
93