Troubleshooting Guide - NuWave OXYPURE ZERO E1000 Owner's Manual

CLEANING & MAINTENANCE
FILTER CLEANING PROCEDURES • TROUBLESHOOTING GUIDE
• Dry thoroughly, away from direct sunlight, in a room with a strong breeze or a fan
to blow air through the filter. Remember: The Bio-Guard Filter carries an 8,000V
charge when it is operating, so it MUST be completely dry inside and out before it
is reinstalled into the OxyPure.
The Ozone Emissions Removal Filter (Filter 3)
To Clean the Ozone Emission Removal Filters
1. Remove the filters. If possible, take them outside to clean.
2. Gently, but thoroughly, clean the filters using a brush-tipped vacuum.
3. Repeat the process on the other side. DO NOT GET WET.
Notes:
DO NOT get the Ozone Emissions Removal Filter wet.
•
• Take this filter outside if at all possible.
• Clean with a brush-equipped vacuum.
• Marks on the filter media are normal and expected. They have no effect on the
filter's functionality.

TROUBLESHOOTING GUIDE

The OxyPure does not turn on.
1. The plug is not in the wall outlet. Plug it into the wall outlet.
2. POWER on the touch pad panel is not on. Press POWER.
3. The Filter Access Panel in the back is off or loose. Make sure the
Filter Access Panel is on securely.
4. If you are unable to close the Filter Access Panel for any reason,
the OxyPure will not operate and you will need to contact
NuWave Customer Service. Exercise caution to ensure the
tabs are not damaged when securing the Filter Access
Panel.
TIMER does not work when pressed.
The OxyPure is not reading the function selected. Press FAN SPEED or AUTO, then
press TIMER.
16 | OxyPure Zero E1000
Sensor
Tab