Epson SC-P600 Service Manual page 74

SC-P600
PG Cam Left
Left CR Shaft Mounting Plate
CR Shaft
50 mm
Bottom of CR Unit
Maintenance
PG Cam Right
Right CR Shaft Mounting Plate
40 mm
15 mm
CR Unit
50 mm
1. Application Point
2. Application Point
3. Application Point
4. Application Point
5. 6. Application Point
Figure 3-8. CR Unit
<Lubrication Point>
1. PG Cam Left / Right
2. Left CR Shaft Mounting
Plate (x3)
CR Guide Plate
3. Right CR Shaft
Mounting Plate (x3)
4. CR Shaft
(Contact points between
the Torsion Spring,
13.14 and the PG
Torsion spring Left)
5. CR Unit
(Contact points of the
CR Shaft)
6. CR Shaft
10 mm
<Type>
1. 2. 3. 4. G-26
5. 6. G-71
<Application Amount>
1. φ 1 mm
CR Guide Plate
2. 13 mg (total amount)
3. φ 2 mm x 40 mm
φ 2 mm x 15 mm
φ 1 mm x whole
circumference
4. φ 1 mm x 2 mm
Application Point
±
5. 6. 140 10 mg (total
amount)
Figure 3-9. CR Guide Plate
<Remarks>

1. Apply on the cam of
the PG Cam Left/Right
Front Tray
with injector.

2. 3. Apply with brush.
 4. 5. Apply with injector.

6. Apply with the
following.
1. Apply the center of the
CR Shaft (x4) with
brush.
2. Apply twice (50 mm
each) on the left side of
the CR Shaft and
spread it with brush.
3. Move the CR Unit
back and forth seven
times slowly to spread
the grease.
4. Apply twice (50 mm
each) on the right side
of the CR Shaft and
spread it with brush.
Front Tray
5. Move the CR Unit Guide Left
back and forth seven
times slowly to spread
the grease.
Application Point
Lubrication Points and Instructions
<Lubrication Point>
Contact point of the CR
Unit
<Type>
Left
G-71
<Application Amount>
φ 2 mm x 70 mm
<Remarks>
On 1 mm from the end of
the frame, apply with
injector and spread it to 10
mm width with brush.
Front Tray Shaft
1 mm
Right
Front Tray Assy
EJ Link Left
Front Tray
Guide Right
Figure 3-11. Front Tray
Revision D
<Lubrication Point>
Contact points (x2)
between the Front Tray
Shaft and the Torsion
Spring, 187.9
<Type>
G-26
<Application Amount>
φ 2 mm x 1 mm
<Remarks>
Apply with injector.
Front Tray Assy
Front Tray Shaft
Application Point
Figure 3-10. Front Tray Assy
<Lubrication Point>
1. Front Tray
EJ Link Right
(Contact points (x5) of
the Front Tray Shaft)
2. EJ Link Left / Right
(x4 each)
3. Front Tray Guide Left /
Right (x10 each)
<Type>
G-74
<Application Amount>
Adequate amount
<Remarks>
---
74
SE Group Confidential (Related Staff Only)