Epson SC-P600 Service Manual page 66

SC-P600
4
3
Color measurement
(1)
"complete" rows
Color measurement
(2)
"not complete" rows
Cursor
(3)
Measurement result
(4)
Stop button
(5)
Measurement start
point
Measuring direction
Times of measurements
per row
When the
measurement fails
 During color measurement, do not allow the calibrator to rub against unmeasured
patches on the chart.
 Prevent the ruler and calibrator from coming off the chart sheet during color
measurement. Doing so will cause incorrect color measurement.
 Do not press the calibrator to the chart too strongly, otherwise the patch may be
damaged.
 If "X" appears repeatedly and the measurement fails continuously, the measured color
value may be far out of the standard range. In that case, end the measurement and go to
the troubleshooting below.
Adjustment
1
2
Measured rows (starting from the left)
Rows to be measured (up to the right end)
Automatically moves right when color measurement of a row is complete.
"O" appears if the color value is within the normal range. Otherwise or the number of patches is
not matched, "X" appears.
Discards the current measurement result and go back to the previous window before measurement.
Figure 2-37. Starting the Color Measurement
Table 2-8. Limitations of the calibrator
i1Pro
Upper left on the color chart
In the direction of the arrow in
only. An error occurs if scanned in the reverse
direction.
Once
Perform the measurement of the failed row.
Cannot go on to the next row until the
measurement is successfully complete.
Details of Adjustments
Measurement start point
5
Orientation of the chart during measurement
Upper left on the color chart

Figure 2-35
Outward (tungsten light): In the direction of
the arrow in

Inward (UV light): In the reverse
direction from the outward scanning
Two times (one cycle)
Perform the measurement of the failed row.
Cannot go on to the next row until the
measurement is successfully complete.
x
SE Group Confidential (Related Staff Only)
Revision D
i1Pro2
Figure 2-35
only.
66