Epson SC-P600 Service Manual page 30

SC-P600
Mist Board Assy / Right side of the Main Frame
Mist Board Cable Holder
Cutout
Electrode cable
Groove A
Groove B
Mist Board Cable Holder
Mist Board Assy Mist Board Cable
Mist Board Cable connector
 When routing the FFCs/cables on the Mist Board Assy and the FFC on right side of the Main Frame, follow the procedure below.
1. Before installing the Cable Holder Right to the Main Frame, route the Mist Board Cable through the groove and ribs (x3) of the Cable Holder Right.
2. Route the Panel FFC along the reference line of the Main Frame, and secure it to the Main Frame with double-sided tape.
3. Route the Mist Board Cable through the hole of the Main Frame.
4. Secure the I/C Holder Unit Cover Open Sensor Cable and Printer Cover Open Sensor Cable with the clamps (x2) and ribs (x2), and then route these
cables through the hole of the Main Frame.
5. Engage the section A of the Cable Holder Right to the Main Frame as shown above, and then secure the Cable Holder Right to the Main Frame with the
hooks (x2).
6. Connect the Mist Board Cable to the Mist Board Cable connector.
 Pull out the electrode cable from the cutout of the Main Frame and route the cable through the groove A and B as shown above, and then connect it to the
Mist Board.
Disassembly/Reassembly
Right side of Main Frame
Step 1 to 4
Cable Holder Right
Panel FFC
Mist Board Cable
I/C Cover Sensor Cable
Printer Cover Sensor Cable
Groove
Step 5
Section A
I/C Holder Unit Cover Open Sensor / Printer Cover Open Sensor
Right side of Main Frame
Main Frame
Main Frame
 Route the I/C Holder Unit Cover Open Sensor Cable and Printer Cover Open Sensor Cable through the hole of the Main Frame as shown above.
 Secure these two cables with clamps (x3) on the front part of the Main Frame.
Clamp
Double-sided tape
Reference line
ASF PE Sensor Holder
Rib
Hook
I/C Cover Sensor Cable
Printer Cover Sensor Cable
Mist Board Cable
 Secure hooks (x4) of the ASF PE Sensor Holder to holes of the Main Frame as shown above.Route the I/C Holder Unit Cover Open Sensor Cable and
Printer Cover Open Sensor Cable through the hole of the Main Frame as shown above.
 Route the following cables through a space between ASF PE Sensor Holder's hooks and the Main Frame.
• I/C Holder Unit Cover Open Sensor Cable
• Printer Cover Open Sensor Cable
• Mist Board Cable
Routing FFCs/cables
Upper side of Main Frame
Clamp
ASF PE Sensor Holder
Rear side of Main Frame
Holes which fix hooks of the Holder
SE Group Confidential (Related Staff Only)
Revision D
30