Ingenico AXIUM DX4000 Portable User Manual page 16

Open the paper cover by lifting the catch located at the top of AXIUM
DX4000 Portable and pull the cover to the rear of the terminal.
Insert the paper roll in the compartment following the directions shown
on the below picture.
Pull the paper up to the top of terminal, maintain the paper and close the
cover.
Press simultaneously on both upper corners of the paper flap until it
clips into position.
Please note that the paper should be cut off upward.
If you insert a new R40 paper roll, tear off the first
length (one complete turn to avoid printing on adhesive
footprint).
Switch off the terminal prior to installing a paper roll. Use only
paper approved by Ingenico.
The use of no-approved paper is likely to damage the printer of
your terminal.
AXIUM DX4000 Portable
10/24
Installing paper roll
16
Banks and Acquirers International Holding SAS
Copyright© 2022 Ingenico –
All rights reserved