Planet IPOE-270 User Manual page 8

 802.3bt PoE++ TP Interface LEDs
LED Color
Green
802.3bt
PoE++
PoE-in-Use
Amber
 DIP Switch
PoE Mode
802.3bt The Standard mode is to provide power to the PD device that
(Default) follows the IEEE 802.3af/at/bt standard.
The Legacy mode supports Ultra PoE. It is to provide power to
Legacy
the PD devices that do not fully follow the IEEE 802.3af/at/bt
standard.
The IPOE-270 series also supports Force Power Mode in the
Legacy the output power of IPOE-270 series in the Legacy
Mode is less than 1 watt for 20 seconds, the Force Mode will
be enabled for 2 seconds. If the loading is still less than 1 watt,
the Legacy Mode will be enabled again.
The IPOE-270 series in the Force Mode will also provide a
maximum 95-watt power to the PD. TO PREVENT THE DEVICES
FROM DAMAGE, please make sure the remote devices support
either the Legacy or Force Mode before turning the DIP switch
to the Legacy Mode.
Adjust the DIP switch to the desired mode before powering on
the IPOE-270 series.
8
Lights to indicate that the port is providing 802.3bt
PoE++ power to remote powered device.
Off to indicate that the port is not providing PoE
power to remote powered device.
Lights to indicate that the port is providing 802.3at
PoE+ power to remote powered device.
Off to indicate that the port is not providing PoE
power to remote powered device.
Description
Function