Table of Contents
Advertisement
5. Apply liberal bead of case joint sealant (butyl) to first
case. Sealant area is shown using a dotted line in
illustration in Step 8. Apply heavy amount to cover
entire shaded area.
DO NOT USE PERMAGUM!
This equipment is to be installed
to comply with the applicable
NEC,Federal, State ,and Local
Plumbing
ATTENTION
Code
ha ving
INSTALLER
6. Slide second case up to first case snugly. Then level
second case to the first case so glass front, bumper
and top are flush.
Do not use bolts to pull cases together.
7. To compress butyl at joint, use two Jurgenson
wood clamps. Make sure case is level from front to
back and side to side on inside bulkheads at joint.
LINE-UP PLATE
(INSERT INTO VERTICAL SLOT)
LINE-UP TAB
(AT BACK OF BUMPER)
FRONT CASE BOLT
(UPPER 3/8" HOLE)
FRONT BODY PANEL REMOVED
FOR ACCESS TO FRONT CASE BOLTING
Installation (Cont'd)
and Construction
jurisdiction.
8. Attach sections together via the bolts pictured in the
illustration below.
9. Apply bead of butyl to top of bulkheads
and slip on stainless steel bulkhead cap. Also apply
silicone to seam between overhead light tubes.
10. Use finger to smooth silicone as thin as possible at
masking tape on inside and outside of rear mullion
(apply additional silicone if necessary). Remove
tape applied on line #4.
11. Remove front, back and end shipping braces.
Q1-FC/FS Refrigerated Wedges and
Standard Cases
Line-up taper pins and line-up plates with holes on adjoining
case. Bolting is located at the rear of the case, behind the
air discharge wall, and behind the front body panel. The
cases are bolted together in front by means of a bracket
located behind the front panel. Remove the front panel by
unscrewing these bottom screws.
LINE-UP PLATE
(INSERT INTO ALUMINUM PROFILE)
USE 1/4"- 20 X 1 1/2" SCREW AT TOP
CASE BOLTING (MULTIPLE 3/8" HOLES)
ACCESS BEHIND AIR DISCHARGE WALL
Q SERIES CASE JOINING GUIDE
6
CASE BOLTING
LINE-UP PIN
(INSERT INTO OUTER 1/2" HOLE)
Advertisement
Table of Contents
