Table of Contents
Advertisement
Installation (Cont'd)
Loosen the fasteners only as needed to allow the glass clamp to slip to the desired position.
Reposition the glass and glass clamp assembly as needed and verify its position by carefully closing the glass to check
clearances.
Once the glass is in the desired position, retighten the fasteners at the hinge arms with the proper wrench.
Recheck the glass position and double check that the fasteners are properly torqued.
IMPORTANT: It is critical that the hinge arm washers or bushings that fasten the hinge arms to the stationary
portion of the upper glass hardware do not have any side pressure on them. Even the slightest side pressure
will result in the failure of the hardware. If the retaining clips or hinge arm washers or bushings at each hinge
arm have any side pressure it is necessary to repeat the adjustment procedure.
When properly adjusted, the hinge arm washers or bushings will have a slight side-to-side free play.
11
Advertisement
Table of Contents
