Maintenance And Care; Inspection Of The Filter - Dantherm HCV 300 Manual

USER MANUAL
Maintenance and care: Inspection of the filter

Inspection of the filter

Introduction Preventive maintenance is necessary at regular intervals if the unit is to operate efficiently
and optimally without unintended stoppages, and to ensure the expected service life of at
least 10 years.
It is important to notice that intervals between filter maintenance can vary according to the
specific environment, and that moving parts are wearing parts, and will need replacement
when worn.
The factory warranty only applies if it can be documented that regular preventive main-
tenance has been carried out as prescribed. The documentation can be a written logbook
containing a company stamp or equivalent.
Summary of
Maintenance must as a minimum be carried out as shown here:
intervals
Interval
Six
months
Annual
Preparation for
Remove the upper part of the front cover.
inspection
The unit has a built-in timer for its filter alarm (every six months as standard). The timer period
Filters - alarm and
for the filter alarm can be changed via the remote control or PC Tool, or it can be reset via the
inspection
alarm button
(6 months - 1 year)
When the timer expires, a filter alarm is triggered. A buzzer will sound and the LED "!" will light
up orange. (If the LED lights up RED, please see Troubleshooting section on pagepage 154.
A short beep will sound, indicating that the filter alarm has been reset correctly.
Step Action
1
2
3

Maintenance and care

Task
Check filters. Replace if necessary
Change filters
Resets the filter alarm when the alarm is triggered
Press for 5
sec.
Resets the filter timer without the timer having expired.
Remove the filters and inspect them after
the filter alarm has been triggered.
Even if only one filter is dirty, we recommend
replacing both filters to avoid imbalance in
the airflow through the unit.
NOTE: Replace the filters at least once a year,
regardless of whether they are dirty or an
alarm has been triggered.
When the filters have been replaced, the
filter alarm must be reset by briefly pressing
the alarm button.
A short beep will sound, indicating that the
filter alarm has been reset correctly.
To be carried out by:
User
User
Illustration
123