Dantherm HCV 300 Manual page 134

Wired remote control
(HCP 10/11)
Optional control
unit (HAC 2)
VOC, humidity and
CO sensor
2
Filters
134
A wired remote control (HCP 10/11) without display can be con-
nected to the unit if the unit's location makes it difficult to reach the
control panel.
The HCP 10/11 provides the same functionality as the control panel.
Additional accessories can be connected to the HCV
unit via an accessory controller: HAC2.
The unit can be equipped with a VOC (air
quality), humidity or CO
2
sensors will continuously monitor the extract
air and adjust the airflow accordingly.
This mode of operation is called demand-
controlled mode. If an HRC Remote Control
is connected, the level will be shown in the
display using the Level 3 icon.
Demand-controlled operation will result in the correct ventilation level with the lowest
possible electricity consumption.
Replacement filters in sets of two standard filters (G4) or of one standard filter plus one F7
filter (pollen filter).
INSTALLATION & SERVICE MANUAL FOR PROFESSIONALS
sensor. Mounted
RH%
Product description: Accessories
VOC
CO
2