Ortech VT-40W Quick Start Manual

LED Vapour Tights
MODEL VT-40W | VT-40WMS
• DO NOT cover the fixtures with flammable materials
• Lamps should always be installed or replaced with care
• Misuse of, or changes to the fixture shall nullify the guarantee
• Before installing the lighting fixtures, please read this instruction manual carefully
• When a lamp is to be cleaned, make the power off and let it cool down completely.
Clean the fixture with a soft cloth and a standard PH neutral detergent
CAUTION
AUTION
CAUTION
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES. Electrical products can
cause death or injury, or damage to property. If in any doubt about the installation or use of this product, consult a competent
electrician. Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock.

INSTALLATION GUIDE

info@ortechindustries.com
www.ortechindustries.ca

WARNING

WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
1. LED Vapour Tight can only be installed by a qualified electrician
2. Before installation or maintenance, please disconnect the power to prevent electric shock
3. Any non-professionals are not allowed to disassemble the lamp
A P P L I C A T I O N
ORTECH reserves the right to modify at any time, without notice, any or all of our product's
features, designs, components and specifications to meet market changes.
13376 Comber Way
Surrey BC V3W 5V9
N O T I C E
• Check the local voltage in accordance with the product requirements
before using the product. Exclusively replaced by the manufacturer or his
service agent or the similar qualified person in order to avoid a hazard
• The lighting fixtures should be installed, connected and tested by a
certified installer based on the local regulations
• Re-lamping only can be done when the power is off and the lamp is
completely cooled down
CAUTION
205 Summerlea Rd
Brampton, ON L6T 4E5
Instruction Manual
1-888-543-6473
1-888-541-6474