Download Print this page

Advertisement

Quick Links

Receptacles
MODEL
MH20-ST
1. MUST be installed in accordance with national and local electrical codes
2. A GFCI receptacle does NOT protect against circuit overload, short circuits, or shocks
3. In the event of a ground fault, a GFCI will trip and quickly stop the flow of electricity to prevent serious injury
4. You can still be shocked if you touch bare wires while standing on a non-conducting surface such as an wooden floor
5. For installation in wet locations, protect the GFCI receptacle with a weatherproof cover that will keep both the receptacle and any plugs dry
6. DO NOT install the GFCI receptacle on a circuit that powers life support equipment because if the GFCI trips, it will shut down the equipment
DO NOT
CAUTION
CAUTION
CAUTION
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.
FEATURES
Should you install it?
Installing a GFCI receptacle can be more complicated than installing a conventional receptacle. Make sure you:
• Understand basic wiring principles and techniques
• Can interpret wiring diagrams & have circuit wiring experience
• Are prepared to take few minutes to test your work, making sure that you have wired the GFCI receptacle correctly
** If you do not fully understand these instructions, you should seek the assistance of a qualified electrician
info@ortechindustries.com
www.ortechindustries.com
WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
1. Receptacles can only be installed by a qualified electrician
2. Turn OFF power at the service panel before working with wiring
3. Use with copper or copper-clad wire. DO NOT use with aluminum wire
4. Please keep the receptacles away from any corrosive substance, and please use dry cloth when you clean it
Application Notice
13376 Comber Way
Surrey BC V3W 5V9
375 Admiral Blvd
Mississauga
,
ON L5T 2N1
Instruction Manual
1-888-543-6473
1-888-541-6474

Advertisement

loading

Summary of Contents for Ortech MH20-ST

  • Page 1 Receptacles Instruction Manual MODEL MH20-ST WARNING WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN. 1. Receptacles can only be installed by a qualified electrician 2. Turn OFF power at the service panel before working with wiring 3.
  • Page 2 Receptacles Instruction Manual MODEL MH20-ST INSTALLATION GUIDE Line vs. Load LINE Cable LOAD Cable A cable consists of 2 or 3 wires Delivers power from the service panel (breaker Delivers power from the GFCI to another panel or fuse box) to the GFCI. If there is only receptacles in the circuit.
  • Page 3 Receptacles Instruction Manual MODEL MH20-ST INSTALLATION GUIDE Connecting the Wires (choose A or B): A — One Cable (2-3 wires) Entering the Box Connecting the Wires (choose A or B): B — Two cables (4 or 6 wires) Entering the Box...
  • Page 4 B)". Make sure that there are no loose wires or loose connections. connections to the GFCI. ORTECH reserves the right to modify at any time, without notice, any or all of our product's features, designs, components and specifications to meet market changes.