Ortech 2400-3CCT Instruction Manual

LED Flush Mounts
MODEL 2400-3CCT
1. RISK OF SHOCK — House electric current can cause painful shock or serious injury unless handled properly. For your safety, always remember to:
A) Turn OFF the power supply at the fuse or circuit breaker box before you install the fixture
B) Double-check all connections to be sure that they are tight and correct
2. This fixture is designed for use in a circuit protected by a fuse or circuit breaker. It is also designed to be installed in accordance with local electrical
codes. If you are unsure about your wiring, consult a qualified electrician or local electrical inspector, and check your local electrical code
3. RISK OF CUTS — some metal parts in the fixture may have sharp edges. To prevent cuts and scrapes, wear gloves when handling the parts
4. Account for small parts and destroy packing material, as these may be hazardous to children
5. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person
6. Terminal block and the suspending accessories are not included. Installation must be performed by a qualified person
CAUTION
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.
INSTALLATION GUIDE
Surface Mount Installation
1) Turn off the switch.
Screw the bracket to the
junction box and ceiling
Semi-flush Mount Installation
1) Turn off the switch.
Screw the semi-flush
mounted bracket to the
junction box and ceiling
info@ortechindustries.com
www.ortechindustries.com
WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
1. LED Flush Mounts are suitable for using in damp locations
2. Please keep the LED Flush Mounts away from any corrosive substance, and please use
dry cloth when you clean it
3. LED Flush Mounts can only be installed by a qualified electrician
4. Before installation or maintenance, please disconnect the power to prevent electric shock
Application Notice
2) Connect the lamp body
2) wires with power cord
2) Connect the lamp body
2) wires with power cord
13376 Comber Way
Surrey BC V3W 5V9
3) Push the lamp towards the
3) ceiling and rotate the lamp
3) to make the mounting
3) plate and the lamp body
3) fixed tightly
3) Push the lamp towards the
3) ceiling and rotate the lamp
3) to make the mounting
3) plate and the lamp body
3) fixed tightly
375 Admiral Blvd
Mississauga ,
ON L5T 2N1
Instruction Manual
4) Turn on the switch to check
4) if the lamp works normally
4) Turn on the switch to check
4) if the lamp works normally
1-888-543-6473
1-888-541-6474