Sanyo FWZH776F Owner's Manual page 45

■
For Wireless Connection
1
Press [ HOME ], then Select "Settings"
"General Settings"
then press [ OK ].
2
Select "Network Connection", then
press [ OK ].
• Connecting method screen will appear.
3
Select "Wireless" using [ K / L ], then
press [ OK ].
• You will be asked to Select "Auto Scan" or
"Manual", or "Easy Connect". Select an
adequate method according to your Wireless
Networks and settings.
Auto Scan Auto Scan
This method lets you Select an SSID* from the SSID
List automatically obtained by performing "Auto Scan".
* SSID (Service Set IDentifier) is a wireless Network
name which is used to identify your Wireless
Networks (access Point) on the Network.
4
Select "Auto Scan" using [ K / L ], then
press [ OK ].
• Access Points List will be Displayed.
appears next to the SSID (access Point) that
is protected with security.
5
Select an access Point to which you
wish to connect this unit using [ K / L ],
then press [ OK ].
6
Enter the Security Key using the
Software Keyboard. press [ OK ].
• For details on how to use the Software
Keyboard, refer to 'Guide to the Software
Keyboard' on page 42.
7
Select "Next", then press [ OK ].
8
"Network",
9
Manual Manual
Select this if you wish to Configure the Wireless
Network settings Manually by entering an SSID and the
Security Key.
4
5
6
7
8
9
10
11
Select "Auto" using [ K / L / 0 / 1 ], then
press [ OK ].
• Connection test will Start and the test result will
be Displayed.
Press [ OK ] to complete the Network
setup.
Select "Manual" using [ K / L ], then
press [ OK ].
• SSID entry screen will appear.
Enter an SSID using the Software
Keyboard.
• For details on how to use the Software
Keyboard, refer to 'Guide to the Software
Keyboard' on page 42.
Press [ OK ].
• Security Method selection screen will appear.
Select an adequate Security mode
using [ K / L ], then press [ OK ].
• Security Key entry screen will appear.
• If you Select "None" for a Security mode,
Connection test will Start and the test result will
be Displayed.
Enter the Security Key using the
Software Keyboard. Press [ OK ].
• For details on how to use the Software
Keyboard, refer to 'Guide to the Software
Keyboard' on page 42.
Select "Next", then press [ OK ].
Select "Auto" using [ K / L ], then
press [ OK ].
• Connection test will Start and the test result will
be Displayed.
Press [ OK ] to complete the Network
setup.
Continued on next page.
EN
EN - 45